Skateboard Wheel Bearing Spacers
by PrecisionSpacers.com

Tired of putting precision bearings on precision trucks and then STILL having to back the axle nut off to get them to spin right? Your spacers are likely to blame. Measure them, and they're likely too short to do what a spacer is designed to do. Look at them, and they're likely tilted on one or both ends, which produces a wobbly roll if you crank them down.

If you're serious about getting the most out of your wheels and bearings, precision spacers are the answer. "Racer Spacers" from PrecisionSpacers.com are custom-machined out of cold-rolled steel, perfectly aligned, slightly oversized (.405") so they actually work.

These spacers will fit any wheel with the nominal .400" (standard) bearing spacing: ABEC 11/Retro (except Stingers), Seismic/3DM, Orangatang, Sector 9 and many others. New! .405" spacers for trucks with 10mm axles (Bear 1052, JimZ, etc.)

Also available: .305" spacers, machined to the same tolerances, for wheels with nominal .300" spacing (e.g., some Kryptonics and Gravity wheels). Note: For 8mm axles only.

The price is $15.00 for four spacers, or $25.00 for eight, plus $1.50 for shipping. Send all payments or inquiries to Jonathan Harms at the e-mail address below. (If you don't want to do PayPal, we can work out other arrangements.)

May 2010 update: 8mm x .405" temporarily sold out! Still in stock: 8mm x .305" and 10mm x .405". (To be put on waiting list for new batch of 8mm x .405", send e-mail to address at bottom of page.)